[1]李兵,王玉镯,高 英,等.型钢混凝土T形柱耐火性能试验[J].长安大学学报(自然科学版),2018,38(06):59-68.
　LI Bing,WANG Yu-zhuo,GAO Ying,et al.Fire resistance performance of T-shaped steel reinforced concrete columns under high temperature[J].Journal of Chang’an University (Natural Science Edition),2018,38(06):59-68.
点击复制

型钢混凝土T形柱耐火性能试验()
分享到：

长安大学学报（自然科学版）[ISSN:1006-6977/CN:61-1281/TN]

卷:
第38卷
期数:
2018年06期
页码:
59-68
栏目:
桥梁与隧道工程
出版日期:
2018-12-01

文章信息/Info

Title:
Fire resistance performance of T-shaped steel reinforced concrete columns under high temperature
作者:
李兵; 王玉镯; 高 英; 刘子卿; 王灿灿; 傅传国
(1. 山东建筑大学 土木工程学院,山东 济南 250101; 2. 山东协和学院 建筑工程学院,山东 济南 250107)
Author(s):
LI Bing1;  WANG Yu-zhuo1;  GAO Ying2;  LIU Zi-qing1;  WANG Can-can1;  FU Chuan-guo1
(1. School of Civil Engineering, Shandong Jianzhu University, Jinan 250101, Shandong, China; 2. School of Architectural Engineering, Shandong Xiehe University, Jinan 250107, Shandong, China)
关键词:
桥梁工程;  型钢混凝土柱;  耐火性能;  试验研究;  轴压比;  偏心距
Keywords:
bridge engineering;  steel reinforced concrete column;  fire resistance;  experimental study;  axial compression ratio;  eccentricity
文献标志码:
A
摘要:
为研究火灾中型钢混凝土T形柱的耐火性能和破坏机理,在高温和竖向荷载的耦合作用下,进行了4个型钢混凝土T形柱试件耐火性能试验研究,对比分析不同轴压比(0.2、0.6)和不同偏心距(0、20、40 mm)影响下型钢混凝土T形柱试件的破坏形态、温度场分布曲线、竖向变形曲线和耐火极限。试验结果表明:各试件的测点升温曲线规律基本一致; 在升温过程中,起初试件表面温度明显高于内部温度,最后内外温度趋于一致。试件中混凝土裂缝的开展对测点温度有影响,表现为裂缝出现越早或裂缝越多则测点升温速率越快; 偏心距越大,加载点一侧竖向裂缝出现越早,裂缝越多,其升温速率也较快; 试件的开裂程度随轴压比和偏心距的增大而增大; 轴心受压试件腹板部位破坏程度高于翼缘板部位,偏心受压试件裂缝主要分布在偏心一侧且多为斜裂缝; 轴压比越小,竖向膨胀越明显、膨胀时间越长; 轴压比越大,耐火极限越小,其中大轴压比试件(轴压比为0.6)的耐火极限比小轴压比试件(轴压比为0.2)降低了57%; 偏心距20、40 mm试件比2种轴压比试件的耐火极限分别降低了10.1%和17.5%。
Abstract:
To study the fire resistance performance and fire failure mechanisms of T-shaped steel reinforced concrete columns, four T-shaped steel reinforced concrete column specimens were tested,under the coupling effect of high temperature and vertical load. The failure modes, temperature field distributions curves, vertical deformations curves, and fire resistance limits of the specimens were analyzed,with different axial compression ratios(0.2 and 0.6)and different eccentricities(0, 20 and 40 mm). The results show that all the temperature rise curves at the measurement points are consistent. As expected, during heating, the surface temperatures of the specimens are higher than the respective internal temperatures,however, after heating, these temperatures are nearly equal. The development of cracks in the concrete specimens affects the measured points temperatures, the earlier the cracks appear or the more cracks formed,the faster the heating rate observed at the measurement points. In addition, the earlier the vertical cracks appear on the side of the load with larger eccentricity, the more cracks formed, shows the faster heating rate. Furthermore, the degree of cracking increases with both the axial compression ratio and eccentricity. The failure degree of the column web is worse than that of the flange plate under axial compression. The cracks in the specimens with eccentric compression are distributed mainly on the eccentric side, and most are inclined cracks. The axial compression ratio is smaller, the vertical expansion is more obvious, and the expansion time is longer. The fire resistance limit decreases with an increase in the axial compression ratio. The fire resistance limit of the specimen with the larger axial compression ratio of 0.6 is 57% lower than that of the specimen with the smaller axial compression ratio of 0.2. Additionally, the fire resistance limits of the specimens with eccentricities of 20 and 40 mm are 10.1% and 17.5% respectively, lower than those of the specimens with axial compression.3 tabs, 14 figs, 26 refs.

相似文献/References:

[1]李宇,朱晞,杨庆山,等.高墩大跨桥梁结构的脆弱性分析[J].长安大学学报(自然科学版),2012,32(01):0.
[2]高亮,刘健新,张丹,等.桁架桥主梁三分力系数试验[J].长安大学学报(自然科学版),2012,32(01):0.
[3]刘旭政,王丰平,黄平明,等.斜拉桥各构件校验系数的常值范围[J].长安大学学报(自然科学版),2012,32(01):0.
[4]尚维波,张春宁.高墩刚构桥系梁抗震分析[J].长安大学学报(自然科学版),2012,32(01):0.
[5]邬晓光,李冀弘,宋伟伟.基于改进响应面法的在役PC桥梁承载力可靠性[J].长安大学学报(自然科学版),2012,32(03):53.
　WU Xiao-guang,LI Ji-hong,SONG Wei-wei.Reliability of existing PC bridge based on improved response surface method[J].Journal of Chang’an University (Natural Science Edition),2012,32(06):53.
[6]石雄伟,袁卓亚,马毓泉,等.钢板-混凝土组合加固预应力混凝土箱梁[J].长安大学学报(自然科学版),2012,32(03):58.
　SHI Xiong-wei,YUAN Zhuo-ya,MA Yu-quan,et al.Prestressed concrete box girder strengthened with comsposition of steel plate and concrete[J].Journal of Chang’an University (Natural Science Edition),2012,32(06):58.
[7]李传习,陶 伟,董创文.斜交墩截面刚度与弯曲正应力[J].长安大学学报(自然科学版),2012,32(03):63.
　LI Chuan-xi,TAO Wei,DONG Chuang-wen.Sectional stiffness and bending normal stress of oblique pier[J].Journal of Chang’an University (Natural Science Edition),2012,32(06):63.
[8]邓继华,邵旭东.带铰平面梁元几何非线性有限元分析[J].长安大学学报(自然科学版),2012,32(03):68.
　DENG Ji-hua,SHAO Xu-dong.Geometric nonlinear finite element analysis of plane beam element with hinge[J].Journal of Chang’an University (Natural Science Edition),2012,32(06):68.
[9]蒲广宁,赵 煜,宋一凡.减梁增肋法加固空心板桥的力学性能[J].长安大学学报(自然科学版),2012,32(06):38.
　PU Guang-ning,ZHAO Yu,SONG Yi-fan.Mechanical properties of strengthening hollow slab bridge based on beam-reduction and rib-addition method[J].Journal of Chang’an University (Natural Science Edition),2012,32(06):38.
[10]党 栋,贺拴海,周勇军,等.基于车辆统计数据的汽车荷载标准值取值与评估[J].长安大学学报(自然科学版),2012,32(06):44.
　DANG Dong,HE Shuan-hai,ZHOU Yong-jun,et al.Choosing and assessment for the standard of vehicle load based on vehicle statistical data[J].Journal of Chang’an University (Natural Science Edition),2012,32(06):44.

备注/Memo

备注/Memo:
收稿日期:2018-06-17
基金项目:国家自然科学基金项目(51878397,51378302)
作者简介:李 兵(1971-),女,山东临清人,实验师,E-mail:rosetea@sdjzu.edu.cn。
通讯作者:王玉镯(1973-),男,山东武城人,副教授,工学博士,E-mail:yuzhuowang@163.com。
更新日期/Last Update: 2018-12-18