[1]刘红坡,艾长发,RAHMAN Ali,等.基于切-拉拔试验的沥青路面层间黏结性能研究[J].长安大学学报(自然科学版),2017,37(03):16-23.
 LIU Hong-po AI Chang-fa,RAHMAN Ali,GAO Xiao-wei,et al.Characterization of interlayer bonding in asphalt pavement based on direct tension test with horizontal loading[J].Journal of Chang’an University (Natural Science Edition),2017,37(03):16-23.
点击复制

基于切-拉拔试验的沥青路面层间黏结性能研究()
分享到:

长安大学学报(自然科学版)[ISSN:1006-6977/CN:61-1281/TN]

卷:
第37卷
期数:
2017年03期
页码:
16-23
栏目:
道路工程
出版日期:
2017-05-31

文章信息/Info

Title:
Characterization of interlayer bonding in asphalt pavement based on direct tension test with horizontal loading
作者:
刘红坡艾长发RAHMAN Ali高晓伟邱延峻
1. 西南交通大学 土木工程学院,四川 成都 610031;2. 西南交通大学 道路工程四川省重点实验室,四川 成都 610031;3. 沙希德·钱伦大学 土木工程系,胡泽斯坦 阿瓦士 83151-61357
Author(s):
LIU Hong-po AI Chang-fa RAHMAN Ali GAO Xiao-wei QIU Yan-jun
1. School of Civil Engineering, Southwest Jiaotong University, Chengdu 610031, Sichuan, China; 2. Key Laboratory of Highway Engineering of Sichuan Province, Southwest Jiaotong University, Chengdu 610031, Sichuan, China; 3. Department of Civil Engineering, Shahid Chamran University, Ahvaz 83151-61357, Khuzestan, Iran
关键词:
道路工程沥青路面拉拔试验层间界面黏结强度水平推力
Keywords:
road engineering asphalt pavement direct tension test (DTT) interface bonding strength horizontal loading
分类号:
U416.224
文献标志码:
A
摘要:
 为研究沥青路面在车辆荷载作用下的层间黏结特性,采用自主研发的能施加水平推力的切拉拔装置进行层间黏结试验。通过正交试验,测试了不同温度、水平推力和黏层油用量等条件下沥青混合料复合试件的层间黏结强度,分析了各因素对黏结强度的影响规律,并通过敏感性分析确定了各因素的影响程度;采用多元非线性回归方法和SPSS统计软件,分析了层间黏结强度与温度、水平推力和黏层油用量的关系,构建了低温、常温、高温3种温度下沥青路面在切拉拔力综合作用下的层间黏结模型,并验证了该模型的可行性。研究结果表明:水平推力削弱了层间黏结整体性能,层间黏结强度降低,当黏层油用量为0.8 kg/m2时,水平推力由0 MPa增至0.2 MPa,其黏结强度降至原有的1/3;随着水平推力的增加,层间黏结强度随黏层油用量的增加呈先增后减趋势,但影响程度逐渐减弱,最大黏结强度所对应的合理黏层油用量为0.8~1.0 kg/m2;随着温度的升高,层间黏结强度迅速降低,温度越高,水平推力对层间黏结强度的影响幅度越大,当温度为50 ℃、水平推力为0.2 MPa时,层间黏结强度降为0 MPa;不同温度区间层间黏结强度下降趋势不同,低温最快、常温变缓、高温最慢;各因素对层间黏结强度影响大小的顺序为温度、水平推力、黏层油用量。
Abstract:
 To research the interface bond characteristics of asphalt pavement under traffic loading, this paper carried out the test to estimate bonding strength between asphalt layers via direct tension test (DTT) which can apply horizontal shear load. By the orthogonal test, this paper not only tested the interface bonding strength of asphalt mixture composite specimen under different temperature, shear load and tack coat application rate, but also analyzed the influence law of each factor on the bonding strength, and the influence degree of each factor was determined by sensitivity analysis. What’s more, the multiple nonlinear regression method and SPSS statistical software were used to analyze the relationship between interface bonding strength and temperature, shear load and tack coat application rate. And the prediction models describing interface bonding strength under the combined effect of tension and shear stress at three different temperature levels including low temperature, middle temperature and high temperature were proposed and their feasibility was demonstrated. The results show that the interface bonding strength reduces once the shear load be applied, and the bonding strength decreases to 1/3 of the original value when the tack coat application rate is 0.8 kg/m2 and the horizontal shear load increases from 0 MPa to 0.2 MPa. With the increase of shear load, the interface bonding strength increases and then decreases with the increase of tack coat dosage, but the degree of influence is gradually weakened. The bonding strength reaches the maximum value when the tack coat dosage is within the range of 0.8 to 1.0 kg/m2. Moreover, the interface bonding strength decreases sharply with the increase of temperature, and the higher the temperature, the greater the effect of horizontal shear load on the interface bonding strength. Once the temperature reaches 50 and the shear load is 0.2 MPa, the interface bonding strength decreases to the value of 0 MPa. The decreasing tendency of the interlayer bonding strength is not the same in different temperature ranges. At low temperatures, there is a sudden fall in bond strength and it continues to drop steadily at medium temperatures, and finally decreases slowly at high temperatures. Influence of each factor on the interlayer bonding strength in descending order is temperature, shear load and tack coat application rate.

相似文献/References:

[1]武建民,祝伟,马士让,等.应用加权密切值法评价基质沥青抗老化性能[J].长安大学学报(自然科学版),2012,32(01):0.
[2]张宜洛,袁中山.SMA混合料结构参数的影响因素[J].长安大学学报(自然科学版),2012,32(01):0.
[3]陈璟,袁万杰,郝培文,等.微观指标对沥青热稳定性能的影响[J].长安大学学报(自然科学版),2012,32(01):0.
[4]周兴业,刘小滔,王旭东,等.基于轴载谱的沥青路面累计当量轴次换算[J].长安大学学报(自然科学版),2012,32(01):0.
[5]李祖仲,王伯禹,陈拴发,等.轴载对复合式路面应力吸收层荷载应力的影响[J].长安大学学报(自然科学版),2012,32(01):0.
[6]关博文,刘开平,陈拴发,等.水镁石纤维路面混凝土路用性能[J].长安大学学报(自然科学版),2012,32(01):0.
[7]翁效林,王玮,张留俊,等.拓宽路基荷载下管桩复合地基沉降变形模式[J].长安大学学报(自然科学版),2012,32(01):0.
[8]穆柯,王选仓,柳志军,等.基于非饱和渗流原理的路基含水率预估[J].长安大学学报(自然科学版),2012,32(01):0.
[9]李振霞,陈渊召.不同类型半刚性基层材料性能的试验与分析[J].长安大学学报(自然科学版),2012,32(01):0.
[10]马 骉,马 晋,周宇鹏.沥青混合料降温收缩断裂特性[J].长安大学学报(自然科学版),2012,32(03):1.
 MA Biao,MA Jin,ZHOU Yu-peng.Cooling shrinkage fracture characteristic of asphalt mixture[J].Journal of Chang’an University (Natural Science Edition),2012,32(03):1.
[11]苗英豪,王秉纲,李超,等.中国公路沥青路面水损害气候影响分区方案[J].长安大学学报(自然科学版),2008,28(01):26.
 MIAO Ying-hao,WANG Bing-gang,LI Chao,et al.Climate zoning for moisture damage of asphalt pavements in China[J].Journal of Chang’an University (Natural Science Edition),2008,28(03):26.
[12]董忠红,吕彭民.轴载与速度对半刚性沥青路面动力响应的影响[J].长安大学学报(自然科学版),2008,28(01):32.
 DONG Zhong-hong,L Peng-min.Influence of axis’s load and speed on dynamic response of semi-rigid base of asphalt pavement[J].Journal of Chang’an University (Natural Science Edition),2008,28(03):32.
[13]任永利,刘涛,梁锡三,等.沥青路面集料加工质量控制[J].长安大学学报(自然科学版),2008,28(01):37.
 REN Yong-li,LIU Tao,LIANG Xi-san.Quality control for aggregate handling in asphalt pavement construction[J].Journal of Chang’an University (Natural Science Edition),2008,28(03):37.
[14]武红娟,王选仓.土基模量随季节变化对沥青路面设计的影响[J].长安大学学报(自然科学版),2008,28(04):7.
 WU Hong-juan,WANG Xuan-cang.Influence of variation of soil base’s modulus with season’s changing on asphalt pavement design[J].Journal of Chang’an University (Natural Science Edition),2008,28(03):7.
[15]蒋应军,戴经梁.土工织物在道路工程防裂中的应用[J].长安大学学报(自然科学版),2007,27(04):18.
 JIANG Ying-jun,DAI Jing-liang.Application of geotextile in preventing reflection cracks in asphalt pavement[J].Journal of Chang’an University (Natural Science Edition),2007,27(03):18.
[16]周谦.寒区沥青路面的合理设计温度[J].长安大学学报(自然科学版),2007,27(05):40.
 ZHOU Qian.Temperature design of asphalt pavement at cold area[J].Journal of Chang’an University (Natural Science Edition),2007,27(03):40.
[17]陈拴发,彭翀,王松根,等.贫混凝土基层沥青路面荷载应力有限元分析[J].长安大学学报(自然科学版),2007,27(06):1.
 CHEN Shuan-fa,PENG Chong,WANG Song-gen,et al.Finite element analysis of stress caused by load on leanconcrete-asphalt overlays composite pavement[J].Journal of Chang’an University (Natural Science Edition),2007,27(03):1.
[18]爱琴,张艳红,郭寅川,等.三类沥青路面结构力学响应的对比分析[J].长安大学学报(自然科学版),2009,29(04):1.
 SHEN Ai-qin,ZHANG Yan-hong,GUO Yin-chuan,et al.Comparative analysis of mechanical response of three typical asphalt pavement structures[J].Journal of Chang’an University (Natural Science Edition),2009,29(03):1.
[19]崔文社,陶晶,张争奇,等.高速公路沥青路面车辙成因试验[J].长安大学学报(自然科学版),2009,29(04):8.
 CUI Wen-she,TAO Jing,ZHANG Zheng-qi,et al.Test on rut causes of expressway asphalt pavement[J].Journal of Chang’an University (Natural Science Edition),2009,29(03):8.
[20]蒋应军,薛航,薛辉,等.半刚性基层预锯缝及铺土工布的路面防裂措施[J].长安大学学报(自然科学版),2006,26(02):6.
 JIANG Ying-jun,XUE Hang,XUE Hui,et al.Preventing Cracks of Asphalt Pavement Based on Pre-cutting Crack and Paving Geotextile at Semi-rigid Type Base[J].Journal of Chang’an University (Natural Science Edition),2006,26(03):6.

更新日期/Last Update: 2017-06-06